Canon GP405 Service Handbook page 23

Mounting the Delivery
Assembly Paper Deflecting
4
Plate Solenoid (SL2)
1) Remove the delivery assembly.
2) Place the delivery assembly upright on a
flat desk.
3) Push in the steel core of the paper
deflecting plate 1 solenoid (SL2) until it
stops.
4) Loosen the adjusting screw, and make
adjustments so that the gap between the
steel core E-ring of the solenoid and the
solenoid frame is about 0.2 mm.
5) Mount the delivery assembly.
Paper deflecting plate
1 solenoid (SL2)
Figure 2-21
CHAPTER 2 STANDARDS AND ADJUSTMENTS
0.2mm
2-13