Table of Contents
Advertisement
UNCOVERED
ZONE
HOLD TIME
VPB OUTPUT
DELAY
LONG PUSH* TIME
HOW TO USE THE REMOTE CONTROL
After unlocking, the red LED
flashes and the sensor can
be adjusted with the remote
control.
When there are several sensors it is recommended to use a different access code for each sensor in order to avoid
changing settings on all of them at the same time.
ADJUSTING ONE OR MORE PARAMETERS
FACTORY VALUES
7
In order to change these settings by remote control, adjust DIP-switch 2 to ON.
2
4
Uncovered zone: increase in case of snow, dead leaves, etc.
In case of false detection, button
When DIP 2 is OFF,
0.1
0.3
0
0.2
VPB1
0
* Long push function: If the push time is longer than 'long push time,' the output will keep
activation until the next push.
The option '0' means disable this long push function.
If the red LED flashes quickly after unlocking, you
need to enter an access code from 1 to 4 digits.
If you do not know the access code, cut and restore
the power supply. During 1 minute you can access
the sensor without introducing any access code.
6
8
10
and
are not recommended.
will change automatically to
1
0.5
1.5
0.6
0.4
0.8
VPB2
0
18
12
14
16
*Measured in specific
conditions and dependant on
(10cm).
application and installation.
2
3
5
1
1.2
1.4
1.6
To end an adjustment session,
always lock the sensor.
cm*
7
9
sec
1.8
sec
sec
Advertisement
Table of Contents
