Table of Contents
Advertisement
SAFETY TIPS
CLASS 1 LASER PRODUCT
CLASS 2 LASER RADIATION
DURING INSTALLATION.
DO NOT STARE INTO BEAM
IEC 60825-1
CAUTION!
Use of controls, adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
The door control unit and
the door cover profile
must be correctly earthed.
INSTALLATION AND MAINTENANCE
Avoid extreme
vibrations.
0°C
Avoid exposure to
sudden and extreme
temperature changes.
• The device cannot be used for purposes other than its intended use. All other uses cannot be guaranteed by the
manufacturer of the sensor.
• The door system manufacturer is responsible for carrying out a risk assessment and installing the sensor and the door system in
compliance with applicable national and international regulations and standards on door safety.
• The sensor manufacturer cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor.
• The warranty is void if unauthorized repairs are made or attempted by unauthorized personnel.
CLASS 1 LASER PRODUCT
CLASS 2 LASER RADIATION
DURING INSTALLATION.
DO NOT STARE INTO BEAM
IEC 60825-1
Only trained and qualified
personnel may install and
adjust the sensor.
Do not cover the
front screens. Remove
the laser window
protection before use.
Avoid direct exposure
to high pressure
cleaning.
The device contains two visible laser beams that can be activated
during the installation process to precisely adjust the position of the
detection field.
Do not look directly into these red beams or laser emitters (Class 2).
The visible laser beams are inactive during normal functioning.
Test the good functioning
of the installation before
leaving the premises.
Avoid moving objects
and light sources in
the detection field.
Do not use aggressive
products to clean
the front screen.
Avoid the presence
of smoke and fog in
the detection field.
When needed, wipe the
laser window only with
a soft, clean and damp
microfibre cloth.
Avoid condensation.
-10°C
Keep the sensor
permanently powered
in environments where
the temperature can
drop below -10° C.
2
Advertisement
Table of Contents
