About The Refrigerator Doors; Door Alignment - GE ZFMB26DRSS Installation Instructions Manual

About the refrigerator doors.

When the door is only partially open,
it will automatically close.
Beyond this stop the door will stay open.
7/16 Socket Wrench
To remove the base
grille, open the doors,
remove the screw at
each end of the base
grille and then pull
the grille straight out.
Door Wine/Beverage Rack
This rack holds up to 5 cans, one bottle of
wine or one 2-liter bottle of soda.
The rack hangs from the sides of the
dairy bin.
To remove:
Empty the wine/beverage rack.
Holding the bottom of the dairy bin,
lift the front straight up, then lift up
and out.
To detach the rack from the dairy bin,
pull the rack's side wires out of the
holes on each side of the dairy bin.
Refrigerator Doors
The refrigerator doors may feel different
than the ones you are used to. The special
door opening/closing feature makes sure
the doors close all the way and are securely
sealed.
When opening and closing the door you
will notice a stop position. If the door is
opened past this stop point, the door will
remain open to allow you to load and
unload food more easily. When the door
is only partially open, it will automatically
close.

Door Alignment

If doors are uneven, adjust the refrigerator
door.
Using a 7/16 socket wrench, turn the
door adjusting screw to the right to
raise the door, to the left to lower it.
(A nylon plug, imbedded in the
threads of the pin, prevents the pin
from turning unless a wrench is used.)
Raise
(on some models)
To replace:
Reattach the rack to the sides
of the bin.
Engage the back side of the bin in
the molded supports on the door.
Then push down on the front of the
bin. The bin will lock into place.
The resistance you feel at the stop
position will be reduced as the door
is loaded with food.
After one or two turns of the wrench,
open and close the refrigerator door
and check the alignment at the top of
the doors.
51