Advertisement
6.
Attach Floor Runners 3 @ 1 1/2" x 3 1/2" x 70"
(Part 1C) to completed floor frames. There are 3
floor runners per 70" side. Use 8 - 2 1/2" Screws
(Part B) per runner.
8.
Complete all floor runner attachments.
Foundations
Note: The floor will be flipped over and floor
runners will sit on your foundation. It is
important to note that having a level foundation
is critical. Choosing a foundation will vary
between regions. Typical foundations can be
concrete pads or patio stones positioned
underneath the floor runners.
10.
Position Plywood Floors - 2 pcs (Part 1D) on top of completed floor frames as shown above.
The plywood is cut slightly smaller than floor framing. Align so plywood seam is tight.
Toll Free 1-888-658-1658
7.
front and rear floor framing but not overhanging.
Center mid
9.
With floor runners attached, carefully flip the floor
runner
over and place on your foundation.
Caution- you will need 2 people to assist you. Be
careful when laying floor down not to bend or twist
floor. When in place, level floor completely.
Measure diagonal in both directions to confirm
square.Both should be approximately 102 1/2". Adjust
floor if necessary.
www.outdoorlivingtoday.com
Page 9
Make sure runners are flush with outside and
sales@outdoorlivingtoday.com
Concrete slab
foundation
Measure Diagonal
Advertisement
