Interlogix Simon XT Installation Manual page 12

LED 2
Solid with one blink
LED L3 (yellow)
L3 flashes with every communication between the module and its radio unit in Idle Mode, and with every communication
with Alarm.com in Connected Mode. In PowerSave Mode, this LED flashes in unison with LED 2.
LED L4 (green)
L4 indicates the LTE signal level as a number of flashes (zero to five bars). The number of bars may not correspond to
the bars shown on your cell phone. A level of 5 bars is obtained only in the strongest signal conditions.
The signal level is updated every ten seconds if it fluctuates, or every 30 seconds if it is fairly stable.
If L4 is not flashing it indicates one of the following states:
• The module is in PowerSave Mode.
• The module just powered up.
• There is no LTE coverage in the area. Alarm.com recommends a steady signal level of 2 or higher for proper
operation of the module.
In Connected Mode, the LED toggles on and off.
LED L5 (yellow)
L5 indicates Z-Wave errors.
LED flashes
2-blink
5-blink
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Panels/Interlogix_Simon_XT/Interlogix_Simon_XT_...
Device status or error
Add node attempt failed because
node already in the network (lasts 60
seconds).
Device status or error
No other nodes are in the network
(lasts until a device is added to the
network)
Learn mode error (lasts 60 seconds)
Description
The device you attempted to add to
a network is already in a network
and must be deleted before it can
join a new network
Description
No devices have been added that
can be controlled by the LTE module
yet.
The device was not successfully
added to the Z- Wave network.
Updated: Tue, 31 Mar 2020 20:51:49 GMT
12