The Handy THTS Instruction Manual page 7

STEP 2

Attach the Wheel Assembly Frame to each side of the Gearbox Assembly and Fixing Connecting
Rod, insert two bolts M6x40 into the fixing connecting rod through the Wheel Assembly Frame.

Make sure the hole in the Gearbox Axle is on the RIGHT SIDE, when assembling, as shown.

Attach the Wheel Assembly Frames & Support Leg onto the Hopper using bolts M6x70, M6 Lock
Nuts and Large Flat Washers Ø6.
NOTE: WE ADVISE YOU DO NOT TIGHTEN THE NUTS & BOLTS COMPLETELY AT THIS POINT.
Note the hole on
the axle of the Gear Box
is on the right side
when assembled
Note the hole on
the axle of the Gear Box
is on the right side
when assembled