Elation Pixel Driver 170 User Manual page 10

INSTALLATION
ELECTRICAL CONNECTIONS
A qualified electrician should be used for all electrical connections and/or installations.
The device connections are as follows. See the diagram below for reference.
• Power Input Connections: top 2 slots on left side of unit (nearest to "Mode" button). These should
be connected to a power source.
• Signal Input Connections: lower 6 slots on left side of unit, comprised of 2 sets of outputs with 3
connections per set. These should be connected to the controller.
• Signal Output Connections: slots on right side of unit. These should be connected to a single strip
of LED tape per driver, via a PIX-AD3 adapter. The Phoenix connector end of the PIX-AD3 will be
connected to the driver, while the XLR end will be connected to the LED tape.
10