Samsung WA10RAQ3IW/YGG Service Manual page 9

4-4 Description of Technical Points
4-4-1 Weight Recognizing Function
1. Weight recognizing function works first washing
operating before water is supplied, not in WOOL
course and Manual function operation (Wash,
...
Rinse, Spin, )
2. Weight recognizing function is cancelled when
water level key is pressed prior to the completion of
weight recognizing function.
3. If the current water level is above lowest at the
beginning of weight sensing, it is automatically
decided as a high level.
4. If you change courses after sensing weight, the
high water level is automatically selected
irrespective of the water level decided by the
sensing of weight.
4-4-2 Water Supplying Function (Option)
1. Relations between water level, frequency & water
supply capacity.
amount of water
RESET
EXTRA LOW
LOW
MED
HIGH
MAXIMUM
2. Relations between Hot/Cold selection & cycle.
Hot/Cold
Wash
selection
Cold Cold
Hot/Cold Hot/Cold
Hot Hot
* The rinse of two times is selected to cold
water automatically.
NOTE: In some regions, 'Digital' course means 'Fuzzy' course.
fre
supplied
0
ℓ
28
ℓ
40
ℓ
53
ℓ
65
ℓ
77
Supplementary
Rinse Prespinning
Watersupply
Cold Cold
Hot/Cold Hot/Cold Hot/Cold
Hot/Cold Hot/Cold Hot/Cold
3. If the water level does not reach to the water level
selected for 60minutes after starting water
supplying, the water supplying Error is displaying
on the display.
4. Supplementary water supplying is performed
every Washing or Rinsing operating. The steps are
as follows.
◎ mentary water supplying is not oversupply water
to the water level selected,
◎ perform the washing or Rinsing operation for 1.5
minutes.
◎ sense the present water level after stopping
Motor.
◎ compare the present water level to the water
level selected.
◎ if present water level < the water level selected,
supply water to the water level selected.
if present water level
continue the washing or Rinsing operation.
◎ But total time of suppler 60 seconds.
4-4-3 Soak Function
1. This function works only when Soak
washing is selected by function select key.
2. It works repeatedly during set time by every 5
minutes(operation for 1 minute and pause for 4
minutes) for 30 minutes after water is filled to
selected water level.
3. If water level is set higher during the Soak
procedure, Soak procedure stops and water
is refilled, and then, keeps on going the Soak
procedure.
4. Washing cycle of 15 minutes begins after
Soak function completion.
Cold
Rinsing times can be adjusted according to
Soak washing procedure.
4-4-4 Fuzzy Function
This function recognizes the quantity of laundry
load and selects the water level by itself and keep
on going washing operation automatically.
8
≥
the water level selected,