Advertisement
3-2-5 Connecting the water supply hose
1. Remove the adaptor from the
water supply hose.
4. Connect the water supply hose to
the adaptor. Pull down part (c) of
the water supply hose. When part
(c) is released, the hose is
automatically connected to the
adaptor, and makes a 'click' sound.
c
3-2-6 Positioning the Drain Hose
1. When there is no threshold, the length of
the drain hose should not exceed 3m.
2. When it is necessary to connect the drain
hose with the drain outlet located far away,
connect the extension hose and
applicable parts (available from dealers or
service centers).
3. Do not install the drain hose where it must
extend over a threshold of 5cm or more ; do
not install where there is a threshold and the
hose must extend for more than 2m.
2m
2. First, using a "+" type screwdriver,
loosen the three screws on the
adaptor.
Next, take the adaptor and hold
parts (a) and (b) with a gap about
5mm between them.
5. Connect the other end of the
water supply hose to the inlet
water valve at the back of the
washer.
Screw the hose clockwise, all the
way in.
(without pump model)
3m
5cm
a
b
4. Other precautions
Do not put the end of the
drain hose into the water.
Do not make the mid part of
the hose than the ends
positioned higher.
4
3. Connect adaptor to the water
tap by firmly tightening the
screws.
Then turn part (b), following
the
arrow, and put (a) and (b)
together.
a
b
If the water tap is a screw type,
connect a water supply hose that
fits to the tap as shown.
Do not place the hose
below the floor level of the
drain outlet.
If the drain hose must be
positioned at a high angle,
install the washing machine
so that it is in an even
higher position.
Hide quick links:
Advertisement
