Advertisement
7-2 Test Mode
(1) Auto Operating Part Test Mode
a. Initial Access Mode: Turn on the course, manual and power keys at the same time
b. Mode Switch: Use the water level keys to switch the mode
c. Display and Control in Initial Access Mode ( ※ Error Detection should occur less than 3 seconds
after the machine starts operating)
Access Test Mode
Mode Selection
Sequential Operation
Input
Stop Operating
(2) Operating Test Mode
1) Initial Access Mode: Turn on the water level, manual and power keys simultaneously.
- In Initial Access Mode, the MICOM version will only be displayed after the LED lights up with
"88-Seg All" displayed, and the course and manual keys are pressed and held down.
- The model name should be displayed two seconds after the display of the MICOM version.
-After the model name is displayed, 《 Operation A 》 should start.
2) Progressive Control in Initial Access Mode: Use the Start key.
-Press the Start key once: " ㅂ " is displayed.
=> Detects the defined high water level before proceeding (Supplies water up to the "High" level)
☞ Error Detection for the water-level sensor, the Ag+and the water supply
- Press the Start key twice: " ㅂ H" is displayed.
=> Detects the defined low level before proceeding (Supplies water up to the "Low" level)
☞ Error Detection for the water-level sensor, the Ag+and the water level
- Start key pressed: "L" is displayed
=> Water supply (Supplies water up to the "High" level)
☞ Error Detection for the water-level sensor, the Ag+and the water supply
-Press the Start key four times: "S" is displayed
=> Dehydrating (Drain water before hydrating to the "Reset" level)
☞ Motor Error Detection: If there are less than 30 pulses after 4 intermediate hydrations
for 30 seconds. Also, Door & UNB Detection
Repeat Ke
None
"01" Displayed
"01" Mechanical Part: 1 sec (On), 0.5 sec. (Off)
Cold Water ->Rinse->Hot Water->ML->NR->Drainage
Start/Pause
"02" All Mechanical Parts: 0.5 sec.(On), 0.5 sec. (Off)
18
Hide quick links:
Advertisement
