Homeright PAINTSTICK EZ-TWIST Instruction Manual page 2

Preparing the PAINTSTICK
NOTE: Prior to painting, protect floors and anything else you do not want damaged by accidental paint spatter.
1. Inspect roller cover for lint. For
best results, rinse roller cover
with water and let dry before
using.
WARNING – DO NOT REMOVE
INNER OR OUTER END CAPS WITH
A SCREWDRIVER! DAMAGE TO
END CAPS CAN OCCUR.
4. Insert roller assembly into
handle assembly and tighten
nut.
• N OTE: When inserting frame,
into handle, the washer on the
frame will not be flush with the
handle.
8. If you have a square paint can,
rest the can cover on top of the
paint can.
• N OTE: Can cover will rest
loosely on top of can.
2. Ensure the outer end cap is in the open positon by depressing PUSH
TO REMOVE side of the tab. Assemble the roller cover to the roller
frame by inserting the frame inside the inner end cap.
Push roller cover onto the roller frame until the roller cover stops.
5. Attach spatter shield by sliding
it over outer end cap and
clipping forked end onto roller
frame. Adjust to any position.
Tips for Painting with the
PAINTSTICK EZ-TWIST
• Inspect roller cover for lint before painting. If needed, rinse with water and let dry before
using.
• When using the PAINTSTICK EZ-TWIST for the first time, it will take most of the paint in
the PAINTSTICK EZ-TWIST tube to saturate the roller cover.
• To prevent dripping, keep roller moving while pushing in the inner handle.
• If the roller starts to skid or slide, stop pushing in the inner handle.
• Partially fill PAINTSTICK EZ-TWIST when painting in tight areas. This reduces the overall
length of PAINTSTICK EZ-TWIST.
• When leaving PAINTSTICK EZ-TWIST unattended for a longer period of time, wrap roller
cover in a plastic bag.
PAINTSTICK EZ-TWIST
® ®
EZ-TWIST
®
6. Insert fill tube through hole in
bottom side of paint can cover
and push until tight and to the
ridge of the fill tube.
2
to Paint
®
3. Lock end cap onto the roller
frame by depressing the
locking tab.
• N OTE: Pull gently on the roller
cover to ensure the roller
cover is secured to the roller
frame.
7. Snap paint can cover onto
paint can.
• N OTE: The can cover will not
fit on some paint containers. In
that case, to fill the PAINTSTICK
EZ-TWIST, omit the can cover
and place fill tube directly into
container. Hold the fill tube with
hand to stabilize as needed.
ENGLISH