Homeright Deck Pro 1 Instructions

Make sure to read all instructions before using this product.
Failure to observe and follow warnings and instructions may
result in severe bodily injury.
SAVE THESE INSTRUCTIONS.
WARNING
Improper use of this product may cause serious injury from
explosion.
Never spray flammable materials or pressure and gas producing
chemicals.
Chemicals can be hazardous when used with sprayers, read
manufactures label.
• Do not use caustics or acids.
• Do not store liquid in tank, dispose of properly.
• Do not let pressurized tank sit in heat or sun, risk of pressure
build up.
• Wear protective eye gear, gloves, and appropriate clothing while
spraying.
• Do not stand over top of tank when pressurizing.
• Do not use if tank is damaged or cracked, under pressure explosion
may result.
• Do not use if hose is leaking or is damaged.
• Do not overfill tank, fill to indicated capacity only.
• Do not pressurize sprayer before ready to use.
• Do not carry sprayer by hose or spray wand.
One Year Limited Warranty
HomeRight warrants this product for one year from the date of purchase,
when this unit is maintained and operated according to the instructions in
the owner's manual, from any defects in material or workmanship
HomeRight will repair or replace defective product at no charge and
return postage-paid to you. This warranty does not cover damage
resulting from improper use, negligence, accidents or normal wear and
tear. If this pump sprayer is used for commercial or rental purposes, this
warranty is void.
Any implied warranty or merchantability or fitness for a particular
purpose is limited to one year following date of purchase. You must
supply proof of purchase. Responsibility is limited to the repair or
replacement for defects in material or workmanship. HomeRight shall not
in any event be liable for any incidental or consequential damages of any
kind, whether for breach of this warranty or any other reason.
Some states do not allow a limitation on how long implied warranties last
or the exclusion of incidental or consequential damages, so the above
limitation and exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights which vary from state to state.
For warranty service, send your product postage-paid along with a
description of what the problem is to: HomeRight, Warranty Dept.,
1661 94th Lane N.E., Minneapolis, MN 55449 or call customer service at
800-264-5442 8:00 am-5:00 pm CST, 763-780-5115 for further assistance.
Deck Pro 1 Gallon Sprayer Instructions
CAUTION
How to Use - For use with thin materials only.
1. Unscrew pump by turning blue handle counterclockwise. Pump
cylinder can then be removed from the tank to allow for filling.
2. Pour material into tank opening. Follow manufacturer's directions
for mixing chemicals. Locate maximum fill line do not overfill tank.
3. Replace the cylinder and blue handle in the correct position and
screw down firmly. Make sure both ends of hose are tightly screwed
into tank and handle.
Note: Avoid getting dirt, grass, and any other objects into the tank,
as it will cause blockage.
4. Pump up the full container until desired pressure for spraying is
achieved, the higher the pressure the better the spray pattern will be.
5. Depress the button to start spraying and for spot spraying. If
desired push down and forward to lock the trigger in a continuous
spraying position.
6. Pump sprayer as needed for continual spraying.
7. After spraying to release pressure, turn sprayer upside down and have
nozzle pointing away from you. Push trigger to let air escape. Turn
sprayer upright and slowly turn handle to unscrew and remove pump
cylinder.
Clean Up
1. Make sure to release pressure from sprayer before removing pump
cylinder.
2. Remove pump cylinder and empty out material. Dispose of material
properly. Follow local ordinances and guidelines for chemical
disposal.
3. Wash out thoroughly and flush out by spraying water through handle.
A mild detergent can be added if needed or use manufacturer's
recommended cleaning solution.
4. Make sure spray tip is cleaned and free of debris.
5. Do not tighten pump handle for storage. Store in a dry area.
Lubricating Pump Cylinder
1. Insert a small screwdriver into one of the visible slots at the side
of the cylinder cap, turn the cap around clockwise. Lift the cap off
of the cylinder and remove the shaft assembly.
2. Clean and put petroleum jelly on pump cup seal to lubricate.
Reinsert into shaft holding handle at 90° angle, insert into shaft,
this will prevent damage to the cup seal.
3. Carefully remove pump valve on the outside bottom of the pump
cylinder.
4. Lubricate cylinder with vaseline and push the small end of the valve
firmly into the middle hole with a screwing motion until it pops
tightly into place.
5. Place cylinder back into sprayer.
1 3