Advertisement
Connect included 3.5mm male to male audio cable (See Fig. 9) to module
12.
"AUX" input jack (See Fig. 8) and route to location where audio device will
reside (within 3ft).
3.5mm male to male cable
Fig. 7
Fig. 8
Module
Fig. 9
12V Accessory
Warning:
Radio in Bose systems may not be able to provide enough
current to power both amplifier and module in which case module will
connect/disconnect at random in which case red accessory wire Fig. 6a
must be used to connect module to an alternate location. If
experimenting this issue, please follow alternate instructions below
From Fig. 6: Disconnect terminal from (default wiring). Connect
13.
terminal to terminal (Terminal not used). Route and connect
other end of accessory wire to
inside driver's lower-dash kick panel. Panel is supported by three screws at
the bottom and three metal/plastic clips at the top. Tap accessory wire to
ignition harness brown
wire.
Plugin control/microphone (See Fig. 10) to "MIC" input on Module (See
14.
Fig. 8)
push-button built-in microphone
ignition harness under steering column
Fig. 10
Advertisement
