Table of Contents
Related Manuals for Discount Car Stereo JAG-HF
Summary of Contents for Discount Car Stereo JAG-HF
- Page 1 Courtesy of: DiscountCarStereo.com Serving the internet community since 1995 JAG-HF QUICK START BLUETOTH INSTALLATION GUIDE FOR SELECT JAGUAR XJ & XK WITH CD CHANGER 1998-03 x308 and 1998-06 x100 Created May 15, 2016 Revised: March 13, 2021...
- Page 2 Introduction: Safety comes first when you’re on the road, so having an intuitive and easy to use Bluetooth kit is essential to reducing driver distraction. The JAG-HF kit is Fig. 1 compatible with virtually all Bluetooth phones, and sounds great whether you are Remove cable from holding tab and disconnect by grasping both plugs using it for mobile conversations or streaming music.
- Page 3 Routing audio cable Use a pry tool to open gap between window pillar and rear deck as seen in Fig. 5. Go into trunk and fish the audio jack (See Fig. 4) through and into the cabin. (See Fig. 6) Fig.
-
Page 4: Bluetooth Module Installation
Bluetooth module installation In our test vehicle (2001 XJR Premium Audio), the Bluetooth module was secured to center armrest sidewall (See Fig. 10) and is our recommendation. In this area you will also find the factory phone plug and cigar lighter wiring, either of which can be used to power the Bluetooth Module (see Fig. - Page 5 Factory connector/Plug Ignition supply wire Ground wire 10-pin Female (white) Pin 10 (light green) Pin 6 (black) 10-pin Male (yellow) Pin 10 (white/green) Pin 6 (black) 14-pin (yellow) Pin 13 (Green) Pin 11n (black) 18-pin male (yellow) Pin 5 (Green) Pin 11 (black) Fig.
- Page 6 Flush Mount to Dash or Panel (requires drilling) Drill a ¾” hole in the dash or panel using a hole saw, step drill bit or equivalent (See Fig. 19) Fig. 17 Control/Mic button Fig. 19 Step drill bit Insert 3.2ft. (1 Meter) USB male terminal (See Fig. 20) through the ¾” hole created in step 1 and connect to USB port on Module (See Fig.
- Page 7 Insert USB male terminal through hole in bracket (See Fig. 25) and connect to USB port on Module (See Fig. 21) Fig. 22 USB head Fig. 25 Snap USB head to mounting plate until flush (See Fig. 26) Fig. 23 Flush mounted to dash Tuck and secure any extra wire from moving parts Flush mount with Support Bracket...
-
Page 8: Bluetooth Pairing And Connection
Bluetooth Pairing and Connection Bluetooth Operation This process is required the first time you use the JAG-HF. After initial pairing, Turn ignition to ACC position and radio ON. the JAG-HF will automatically reconnect with the paired phone upon entering Press “CD” button on radio. Track or Disc number are displayed only if vehicle. -
Page 9: Phone Commands
Activate Voice Control Press/hold button for 2 seconds What’s the major difference between the JAGCD-HF and JAG-HF? The JAGCD-HF requires and retains the CD changer, the JAG-HF requires Notes: but does not retain use of the CD changer. (Changer remains connected If audio playback is distorted or low, adjust volume on phone. - Page 10 • We’re not liable for misuse of this product. Email support@discountcarstereo.com © 1995-Mar-21 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject to change without notice. Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or...