Weee; Inspection And Acceptance Of Pin Brazing Equipment (Goods); Warranty - BAC EASYBOND MK2 Operation And Maintenance Manual

13.

WEEE

Do not dispose of this product as unsorted municipal waste.
Contact BAC Corrosion Control Ltd (BAC) or a qualified recycler for disposal.
The European Union also adopted Directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE), with requirements that went into effect August 13, 2005. WEEE is intended
to reduce the disposal of waste from electrical and electronic equipment by establishing
guidelines for prevention, reuse, recycling and recovery.
BAC has already modified its practices and processes to conform to the requirements in this
important Directive.
The Easybond equipment has been tested to, and is in compliance with the following
standards:
BSEN 61000-6-4:2007 + A:2011 Generic emissions standard for industrial equipment
BSEN 61000-6-2:2005 Generic immunity standard for industrial equipment
14.

INSPECTION AND ACCEPTANCE OF PIN BRAZING EQUIPMENT (GOODS)

The Customer will notify in writing (otherwise that on a delivery document) (a) BAC Corrosion
Control Ltd and any carrier of any claim regarding the quantity or condition of Goods delivered
or any damage to them within 5 days of delivery and (b) BAC Corrosion Control Ltd of any claim
regarding any defect which should be apparent on reasonable inspection within 15 days of
delivery, time being of the essence. The Warranty will apply to any such defect or damage. If no
such notice is given, so far as concerns those matters the Customer will be deemed to have
accepted the Goods and that they conform with the Contract.
15.

WARRANTY

1. The following warranty will apply to the pin brazing equipment (Goods):
The pin brazing equipment (excluding pin brazing batteries) will correspond with their
specification and description and sample (if any) at the time of delivery and if within twelve (12)
calendar months of the Goods being delivered by the Company or, as the case may be,
completion of the supply of any services (or such other period as BAC Corrosion Control Ltd
may agree in writing) any defect in the Goods is discovered under normal use which is directly
attributable to the Goods not so corresponding or faulty design, materials or workmanship, or a
valid claim is made under paragraph 7, BAC Corrosion Control Ltd will at its option and expense
remedy the defect or damage by replacement or repair or refund the purchase price of the
defective or damaged Goods.
2 The warranty will be subject to the following conditions:
(a) it will not apply to any defect or damage resulting from any:-
(i) alteration of the Goods without BAC Corrosion Control Ltd.'s prior written consent,
incorrect installation (except by BAC Corrosion Control Ltd), incorrect storage,
BAC Document Number: Easybond MKII Manual V03 28/08/13 Page 29 of 32