Grandstream Networks GVC3202 Quick Installation Manual page 6

http://arttel.ru
11. Manage the wire harness with the Hook-and-loop
CONNECTING THE GVC3202
1. Connect the LAN port of the GVC3202 to the RJ-45 socket of a hub/switch or
a router (LAN side of the router) using the Ethernet cable.
2. Connect the HDMI [1] port of the GVC3202 to the HDMI port of the main display
device (e.g., TV) using the HDMI cable. Connect HDMI port 2 if you have
additional display devices.
Note: Please make sure to follow the port order when connecting HDMI port 1
and 2. The GVC3202 will not work correctly if connecting HDMI port 2 without
HDMI port 1 connected.
3. Connect the USB cable of the speaker to the "SPKR" port of the GVC3202.
7
http://arttel.ru/shop/videokonferentsii/grandstream-gvc3202
8. Align Part A and Part B at the 2
holes as highlighted below. Install
screw Type 2 to each of the hole
and tighten it.
9. Place GVC3202 on the top of the
wall mount bracket Part A. On the
wall mount bracket Part A, the
ORFDWLQJ SLQ VKRXOG ¿W LQWR WKH KROH
on the bottom of the GVC3202.
10. Tighten the built-in screw on wall mount
bracket Part A to make sure the GVC3202
¿WV VHFXUHO\
fastener on wall mount bracket Part B.
Note: "USB" port of the GVC3202 is not for connecting speaker. Connecting
speaker to "USB" port might cause speaker work improperly.
4. Connect the 12V DC output plug to the power jack on the GVC3202; plug the
power adapter into an electrical outlet.
VGA IN
HDMI IN HDMI OUT SD Card SPEAKER
Port 1/2 Slot Port
5. The OLED in the front of the GVC3202 will display booting up information.
Before continuing, please wait for the IP address information to show up on the
OLED. The display device (e.g., TV) will show the idle HOME screen with IP
address on the top status bar as well.
Lens
OLED. It shows IP
address information
after bootup. For example,
IP: 192.168.40.123
RESET
USB Port LAN Port DC-IN 12V
LED Indicator
8