Caring For Your Steam Pocket® Mop; Ordering Additional Accessories - Shark KLIK N' FLIP S6003EUDB Owner's Manual

Caring for Your Steam Pocket
fig. 12
fig. 13
AFTER USE AND STORAGE
1
Press the Steam Control Button until the three lights below start
to blink, indicating that you are in Standby mode. Unplug the
cord from the outlet and place the Steam Mop into the upright
position. Let it cool.
2 To remove the Dirt Grip pad, lift the Steam Mop straight up by the
handle until the Klik n' Flip® Mop Head is hanging straight down.
Press the Release button on the back of the Steam Mop body, and
both sides of the Klik n' Flip® Mop Head will drop open, releasing
the pad. Once the pad has been released, close the Klik n' Flip® Mop
Head.
3 If the Klik n' Flip® Mop Head is not attached to the mop, the pad
can still be removed. Press the two red secondary pad release
buttons located on the sides of the Klik n' Flip® Mop Head post to
release the pad. (fig. 12)
4 Empty the water tank before storing. To empty the tank, hold the
Steam Mop beside a sink. Open the water tank lid, then lean the
unit over the sink. Let the water drain out, then close the lid.
5 To store the Steam Mop, wait until after it has cooled and the
steam has been released. Then remove the Klik n' Flip® Mop
Head and hang the Steam Mop by its handle on a large hook (not
included). (fig. 13)
6 Store the filling flask by attaching it to the top handle pole of the
Steam Mop.
38
Mop
®
fig. 14
fig. 15
DIRT GRIP PAD CARE INSTRUCTIONS
Care
Machine-wash the Dirt Grip pads separately with warm water using
liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT, OR FABRIC SOFTENERS
as they may damage or leave a coating on the Dirt Grip pads that will
reduce their cleaning performance and absorbency. Dirt Grip pads
should be line-dried or tumble-dried on a low setting, as this will
extend the life of the microfiber fabric. (fig. 14)
Loose fibers can indicate wearing of the microfiber fabric. Do not pull
the loose fibers, as this can cause the weave to come undone. Simply
trim the loose fibers with scissors. (fig. 15)
Replacement Dirt Grip pads
For best cleaning results, we recommend replacing your Dirt Grip
pads every 3 to 4 months following normal use. As with any fabric,
dirt particles, grease, friction, and repeated washing can cause the
fibers to break down, and you may notice an increase in the effort
needed to push or pull the Steam Mop.
You can purchase replacement Dirt Grip pads and other accessories by
visiting sharkclean.eu
STEAM NOZZLE CARE
If you believe the main steam nozzle or the Steam Blaster nozzle is
clogged, please contact Customer Service www.sharkclean.eu

Ordering Additional Accessories

ACCESSORY
Klik n' Flip® Mop Head
Great for all-purpose cleaning. Get an extra boost for tough stains from the Steam Blaster, and
cut your cleaning time in half with the hands-free two-sided pad.
Dirt Grip Pad
Double-sided pad. Easy, hands-free installation and removal. Washable and reusable.
Triangle Scrubber Head
Triangle shape is perfect for cleaning corners and hard-to-reach areas. Equipped with a
Steam Blaster to help loosen stains and a deployable scrubber to tackle stuck-on spots.
Triangle Scrubber Pad
Ideal for cleaning corners and other hard-to-reach spaces. Easy to install and remove.
Filling Flask
Filling line makes it simple and convenient to fill the water tank. Flask attaches to the
handle for easy storage.
Carpet Gider
Use to groom and freshen carpeting or area rugs.
s h a r kc l e a n . e u 39