Caring For Your Steam Pocket Mop - Shark Genius S6002 Series Owner's Manual

Caring for Your Steam Pocket
fig. 12
AFTER USE AND STORAGE
1
Press the Steam Control button until the light below
starts start to blink, indicating that you are in Standby
mode. Unplug the cord from the outlet and place the
Steam Mop into the upright position. Let it cool.
2
To remove the Dirt Grip
up by the handle until the Genius
straight down. Press the Release button on the back of
the Steam Mop body, and both sides of the Genius Mop
Head will drop open, releasing the pad. Once the pad
has been released, close the Genius Mop Head.
3
If the Genius Mop Head is not attached to the mop, the
pad can still be removed. Press the two red secondary
pad release buttons located on the sides of the Genius
Mop Head post to release the pad (fig. 12).
4
Empty the water tank before storing. To empty the
tank, hold the Steam Mop beside a sink. Open the
water tank lid, then lean the unit over the sink. Let
the water drain out, then close the lid.
5
To store the Steam Mop, wait until after it has cooled
and the steam has been released. Then remove the
Genius Mop Head and hang the Steam Mop by its
handle on a large hook (not included) (fig. 13).
6
Store the filling flask by attaching it to the top handle
pole of the Steam Mop.
9 1-800-798-7398
fig. 13
pad, lift the Steam Mop straight
™
Mop Head is hanging
™
Mop
®
fig. 14
DIRT GRIP PAD CARE INSTRUCTIONS
Care
Machine-wash the Dirt Grip pads separately with warm
water using liquid detergent.
NEVER USE BLEACH, POWDERED DETERGENT, OR
FABRIC SOFTENERS as they may damage or leave
a coating on the Dirt Grip pads that will reduce their
cleaning performance and absorbency. Dirt Grip pads
should be line-dried or tumble-dried on a low setting, as
this will extend the life of the microfiber fabric (fig. 14).
Loose fibers can indicate wearing of the microfiber
fabric. Do not pull the loose fibers, as this can cause the
weave to come undone. Simply trim the loose fibers with
scissors (fig. 15).
Replacement Dirt Grip pads
For best cleaning results, we recommend replacing your
Dirt Grip pads every 3 to 4 months following normal use.
As with any fabric, dirt particles, grease, friction, and
repeated washing can cause the fibers to break down, and
you may notice an increase in the effort needed to push or
pull the Steam Mop.
You can purchase replacement Dirt Grip pads and
other accessories by visiting sharkclean.com or calling
1-800-798-7398.
STEAM NOZZLE CARE
If you believe the main steam nozzle or the Steam Blaster
nozzle is clogged, please contact Customer Service at
1-800-798-7398 or consumer-services@sharkninja.com
fig. 15
™