To Activate Group Mode (Group Mode Recording) - Sony MZ-N707 Operating Instructions Manual

How is group information
recorded?
When recording in group mode, the group
information is written to the disc name
recording area automatically.
This information consists of text strings
that are written as shown in the following
example.
Disc name recording area
Example
1
1
Disc name: "Favorites"
2
Group name for tracks 1 to 5: "Rock"
3
Group name for tracks 6 to 9: "Pops"
Therefore, the above character string is
displayed in its entirety as the disc name
if you load an MD recorded in group
mode into a system that does not support
group mode, or if you try to edit the
contents of a disc on this recorder with the
group mode turned off.
It is possible to change the
character string by doing
"Relabeling recordings" procedure
in the "Labeling/relabeling
recordings" (page 43). Note that if
you rewrite this character string by
mistake, you may be unable to use
the group function of that MD.
Notes
• The group function setting is stored even if
you eject the MD or turn off the recorder.
• In group mode, the recorder treats all tracks
without group settings as belonging to the last
group on the disc. The last group is indicated
in the display window on the recorder as
"Group --". Within a group, the tracks appear
in their order on the disc, not their order
within the group.
28
-GB
2 3
.
REC
END SEARCH
DISPLAY
Control
To activate group mode
(Group Mode Recording)
To record tracks in group mode, you must
first turn group mode on before the start
of recording.
On the recorder
1
Press GROUP for 2 seconds or more.
" " lights up and group mode turns
on.
To cancel group mode, press GROUP
for 2 seconds or more again.
On the remote control
1
Press DISPLAY for 2 seconds or
more.
2
Turn the control until "GROUP"
flashes in the display, and then press
x to enter.
./>
GROUP
x