Instructions For Use; Fitting And Removing The Parts - Cuisinart CORDLESS MINI PREP PRO Manual

Instructions for Use

Before use
A. Charging Your Cordless Mini Prep Pro
The batteries in your Cordless Mini Prep Pro have not been fully charged.
Before using, the batteries must be charged until all three blue lights are
illuminated. With a full charge, your Cordless Mini Prep Pro will run for
approximately 15 minutes, depending on your recipe. Your Cordless Mini
Prep Pro will be fully charged in approximately 2 hours.
N.B. To charge the product, insert the micro USB end, of charging lead,
into the charging port at the back of the main unit. Plug the USB end
directly into the adapter plug and then into a mains supply outlet.
Battery Life Indicator Lights
The indicator lights will flash blue when the battery is being charged. When
all three lights are illuminated, this means the battery is fully charged and
is then ready to use. As the battery starts to run down, the indicator lights
will turn off. The battery will need to be recharged when the last indicator
light is flashing. If the battery has completely run down on the unit, it will
not operate.
B.

Fitting and removing the parts

Place the housing base on a flat, dry stable surface.
n
Place the work bowl over the motor base, with the handle facing forward
n
and positioned slightly to the left of the control panel (the bowl will slot
onto the base).
Turn the bowl in an clockwise direction until it locks into position on
n
the housing base.
N.B. The work bowl must be securely locked into position. The bowl
will be in the correct position once the handle is central to the control
panel.
Carefully lift the blade assembly, holding the central plastic stem and
n
place over the motor spindle. Push the blade down until it clicks into
place. The lower part of the blade assembly should almost touch the
bottom of the work bowl.
N.B. Always hold the blade assembly from the plastic stem. Never touch
10