Instructions For Use; A Fitting & Removing The Parts - Cuisinart ECH4U Manual

Instructions For Use

A Fitting & removing the parts
1. Place the housing base on a flat, dry, stable surface.
2. Place the work bowl over the motor base with the handle facing forward and positioned
slightly to the left of the control panel (the bowl will slot onto the base).
3. Turn the bowl in an anticlockwise direction until it locks into position on the housing
base.
N.B. The work bowl must be securely locked into position. The bowl will be in the
correct position once the handle is central to the control panel.
4. Carefully lift the blade assembly, holding the central plastic stem and place over the
motor spindle. Push the blade down until it clicks into place. The lower part of the
blade assembly should almost touch the bottom of the work bowl.
N B Always hold the blade assembly from the plastic stem Never touch the blade
as it is very sharp
N B Never place the blade on the motor shaft until the work bowl is locked into
place
N B Always insert the blade in the work bowl before adding ingredients
5. Add the food you wish to process.
6. Place the lid on the work bowl with the small tab to the left of the work bowl handle.
Turn the cover anticlockwise (toward handle) to securely lock.
N B The work bowl and lid must be tightly locked into the interlock device Once
securely fitted a loud click is heard If both the work bowl and the lid are not
fitted securely the processor may work intermittently
7. To remove the lid, hold the housing base with your left hand, securely grip the handle
on the top of the lid and rotate it in a clockwise direction.
N B Make sure the motor has completely stopped and the blade has stopped moving
before removing the lid
ATTENTION: The lid must always be removed before fitting or removing the work
bowl from the base
8. To remove the blade, gently pull up to disengage blade lock away from the motor
spindle holding the plastic stem.
9. To remove the work bowl, firstly ensure the lid has been removed. Hold the housing
base with your left hand, then hold the work bowl handle with your right hand and
turn in a clockwise direction to unlock and lift away from the housing base.
8