Slide The Tubular Motor Into The Winding Shaft; Preparatory Work When Using Precision Tubes - RADEMACHER RTBS Operating And Assembly Manual

Slide the tubular motor into the winding shaft (Figure
For Small / Medium only
Preparatory work when using precision tubes (Figures
5.a
5.b
5.c
5.d
22
Never strike the motor (9) vio-
lently to insert it in the winding
shaft (5).
This will destroy it.
RolloTube Small
1 2
RolloTube Medium
1 2
)
1.
First slide the driver (8) into the 1. winding shaft (5).
IMPORTANT
For winding shaft with interior seams, the motor (9) must
have sufficient clearance.
2.
Next, press the winding shaft (5) completely onto the
adapter (10).
IMPORTANT
Take care that the adapter (10) does not slide off of the
limit ring (18) on the drive head (12) during assembly, or
a malfunction will occur; see page 27.
- )
1.
Measure the distance between the adapter and the
rear third of the driver and mark this distance on
the precision tube.
2.
Saw a notch 1 at the end of the precision tube so that
the raised part 2 of the adapter can be pushed fully
into the tube.
NOTE
◆ There must be no play between the notch 1 and the
raised part 2.
◆ The dimensions of the notch 1 depend on the type
of tubular motor, see figures.
3.
Den Rohrmotor in das Präzisionsrohr schieben.
EN
DE EN NL FR IT ES