Important Installation Instructions - RADEMACHER RTBS Operating And Assembly Manual

Important installation instructions

IMPORTANT
◆ Please compare the voltage/frequency specifications
on the type plate with those of your local power
supply network before installation.
◆ Disassemble or deactivate all cables and equipment
that will not be needed for operation before install-
ing the tubular motor.
> The moving parts of drives that are operated at less
than 2.5 m height from the floor must be protected.
> If the tubular motor is controlled with a preset
OFF switch this switch must be fitted within view
of the tubular motor, at a minimum height of 1.5
m and away from moving parts.
◆ The roller shutter box cover must be easily accessible
and removable.
◆ Never dismantle the stoppers from the final roller
shutter slat.
Installing the tubular motor at an angle can cause the
tubular motor or roller shutter to be damaged. For
example, a roller shutter wound at an angle can block
the drive and cause damage.
◆ Always ensure that the tubular motors and bearings
are mounted horizontally.
◆ Please ensure that the winding shaft (5) and the
roller shutter (17) can move down easily and freely
after installation is complete.
◆ The roller shutter (17) may not run over the bearing,
the roller capsule (4) or the drive head (12) during
operation.
◆ Ensure that the winding shaft (5) and the rigid shaft
connectors (6) do not touch the drive (9). They
may not rub against the tubular motor (9) during
operation.
20
For automatically operated awnings:
◆ Awnings must be fitted in such a way that there is a
minimum distance of 0.4 m between the awning and
objects in its immediate proximity when it is fully
extended.
◆ The lowest point of any awning system must not be
less than 1.8 m high.
Incorrectly dimensioned drives and counter bearings
can cause the roller shutter system to be damaged.
◆ Only use original bearings supplied by the manu-
facturer. Thirdparty drives and counter bearings
must be selected in accordance with the torque
specifications of the respective tubular motors.
Risk of injury in the event of incorrect installation
(impact injuries and contusions).
◆ The motor can eject from the drive bearing in the
event of incorrect installation/fastening. Fasten
the tubular motor with the securing devices
provided.
Mortal danger in the event of operation without
configured end points.
◆ The end points must be configured in order to en-
sure safe operation. In order to do so, please
refer to the corresponding chapter in this manual
provided on page 25.
EN
DE EN NL FR IT ES