Dhw Cylinder Settings; Setting The Current Operating Mode - Viessmann VITOCAL 300 Operating Instructions Manual

DHW cylinder settings

Setting the current operating mode

This setting option for the operating mode only affects this change of
operating mode until the next change activated by the timer program.
Operating modes for DHW cylinder:
"On" The heat pump heats the DHW cylinder to the set temperature.
"Off" The DHW cylinder is currently not heated.
Additional operating modes for DHW cylinders with electric immersion
heater:
"E use" The DHW cylinder with electric immersion heater will be heated
to the temperature set by your specialist (standard = 60 ºC).
"High Additional function for DHW heating:
loading" The electric immersion heater briefly heats the DHW cylinder to
the set temperature.
DHW cylinder 1
Current op. mode
DHW cylinder temp.
Timer/switching times
>>
± °
20
: ON
: 45.0
<<
BACK
STANDA
Open the programming unit flap and
press the following keys:
1. C for "Programme".
B
2. for "DHW cylinder 1".
The "current operating
mode" is highlighted.
Your specialist will have
set the DHW to a
permanent operating
mode if this menu item
is not shown.
3. >> / << press until the required
operating mode is
shown.
BACK
4. press to confirm.
Close the programming unit flap.