Advertisement
DO NOT stand on or use a hose as a step. DO NOT pull or apply external forces to the hose. The hose may fail and
cause injury.
Keep all persons away from the working area. Mechanisms controlled by fluid power can become hazardous if a hose
fails. Lifted mechanisms can fall to the ground, machine steering may fail, etc.
Stay clear of a pressurized hose assembly that has blown apart. Hose fittings can be thrown off at high speed and a
loose hose can whip around with great force.
Hydraulic fluid can reach high temperatures. Allow fluid to cool before servicing the system.
Escaping fluid under pressure may form a mist or fine spray which can flash or explode upon contact with an ignition
source.
Vibration can reduce hose service life. Make sure all retaining clamps and/or devices are secured.
Environmental conditions can cause hose and fittings to deteriorate. Inspect hydraulic hoses periodically. Replace
worn or damaged hoses and fittings.
General maintenance safety
Keep the area used for servicing the machine clean and dry. Clean up spilled fluids.
Service the machine on a firm, level surface.
Install guards and shields after you service the machine.
Close all access doors and install all panels after servicing the machine.
Do not attempt to clean, lubricate, clear obstructions, or make adjustments to the machine while it is in motion or while
the engine is running.
Always make sure that working area is clear of tools, parts, other persons and pets before you start operating the
machine.
Unsupported hydraulic cylinders can lose pressure and drop the equipment, causing a crushing hazard. Do not leave
equipment in a raised position while parked or during service, unless the equipment is securely supported.
Jack or lift the machine only at jack or lift points indicated in this manual.
Incorrect towing procedures can cause accidents. When you tow a disabled machine follow the procedure in this
manual. Use only rigid tow bars.
Stop the engine, remove the key, and relieve pressure before you connect or disconnect fluid lines.
Stop the engine and remove the key before you connect or disconnect electrical connections.
Scalding can result from incorrect removal of coolant caps. Cooling systems operate under pressure. Hot coolant can
spray out if you remove a cap while the system is hot. Allow the system to cool before you remove the cap. When
you remove the cap, turn it slowly to allow pressure to escape before you completely remove the cap.
Replace damaged or worn tubes, hoses, electrical wiring, etc.
The engine, transmission, exhaust components, and hydraulic lines may become hot during operation. Take care
when you service such components. Allow surfaces to cool before you handle or disconnect hot components. Wear
protective equipment when appropriate.
When welding, follow the instructions in the manual. Always disconnect the battery before you weld on the machine.
Always wash your hands after you handle battery components.
Wheels and tires
Make sure that tires are correctly inflated. Do not exceed any recommended load or pressure. Follow the instructions
in the manual for proper tire inflation.
INTRODUCTION
47816352 10/12/2014
7
Find manuals at https://best-manuals.com
Advertisement
