Advertisement
Do not weld or flame cut any items that contain flammable material. Clean items thoroughly with non-flammable
solvents before welding or flame-cutting.
Do not expose the machine to flames, burning brush, or explosives.
Promptly investigate any unusual smells or odors that may occur during operation of the machine.
Power Take-Off (PTO)
PTO-driven machinery can cause death or serious injury. Before you work on or near the PTO shaft or service or
clear the driven machine, put the PTO lever in the disengage position, stop the engine, and remove the key.
Whenever a PTO is in operation, a guard must be in place to prevent death or injury to the operator or bystanders.
When doing stationary PTO work, keep clear of all moving parts and make sure that appropriate guards are in place.
Never use a spline adapter:
• Match the right tractor PTO spline and speed with the PTO driveshaft provided with an implement. This will assure
proper geometry and operating speed.
• Never operate 540 RPM implements at 1000 RPM.
• Never operate 1000 RPM implements at 540 RPM.
• Use of PTO adapters will void the warranty of the driveshaft, and the PTO drive train of the machine and implement.
• For correct hitch geometry, refer to the operator's manual.
Reflectors and warning lights
You must use flashing amber warning lights when you operate equipment on public roads.
INTRODUCTION
47816352 10/12/2014
9
Advertisement
