Table of Contents
Advertisement
INTRODUCTION
This service manual has been prepared with the latest
service information available at the time of publication.
Read the service manual carefully before doing any
service on the machine.
Right-hand and left-hand, as used in this manual, is
determined by facing the direction the machine will travel
when in use.
The photos, illustrations, and data used in this manual
were current at the time of printing, but due to possible
production changes, your machine can vary slightly. The
Manufacturer reserves the right to redesign and change
the machine as necessary without notification.
PAGE NUMBERS
All page numbers are made of two numbers separated by
a dash, such as 04-9. The number before the dash is the
division number. The number following the dash is the
page number in that division. The page number will be at
the lower right-hand or lower left-hand corner of each
page.
UNITS OF MEASUREMENT
Measurements are given in metric units followed by the
equivalent in U.S. units. Hardware sizes are given in
millimeters for metric hardware and inches for U.S.
hardware.
REPLACEMENT PARTS
To receive efficient service, always give the dealer the
following information:
•
Correct part description or part number.
•
Model number of the machine.
•
Serial number of the machine.
MACHINE IDENTIFICATION
FIG. 1: Each machine is identified by a model and serial
number on the serial number plate (1). The serial number
plate is located on the left-hand end of the header.
4283389M1
GENERAL INFORMATION
General Information
FIG. 1
1
N306918
02-3
Advertisement
Chapters
Table of Contents
