Loading And Unloading - Kendon Stand-Up TRIKE/SPYDER/SIDECAR Ride-Up SRL Owner's Manual

6.4 Loading Ramps, Storage for storage
-
Store your loading ramps under the rear section of the trailer
-
If the rear section becomes too heavy for easy operation, the loading
ramps can be completely removed and stored next to the trailer
-
Slide the ramps approximately 2/3rds under the rear section
-
Using a lock or locking pin, secure the ramps in place using the
Loading Ramp Hooks on the end of the trailer's Rear Section and
the Loading Ramp Storage Loop that should line up with the Loading
Ramp Hook
-
Examples of the ramps properly locked in place for storage:

7.0 LOADING AND UNLOADING

When properly performed, the loading/unloading procedures should be
very safe and easy on your Kendon Ride-Up SRL Trike/Spyder/ Sidecar
Trailer. Loading and unloading a vehicle requires certain skills and
techniques. Kendon recommends using two spotters while practicing the
loading and unloading technique with your bike. Most incidents occur
from first-time users with no experience in loading and unloading a
motorcycle. For your added protection, Kendon recommends wearing
your riding gear during the loading/unloading process.
WARNING: Your trailer MUST be securely attached to a tow vehicle
BEFORE attempting any loading or unloading procedure.
7.1 Preparing your loading ramps
-
Remove the locks or pins attaching the ramps to the Rear Section
-14-