Table of Contents
Advertisement
-
Slide one section of loading ramp from beneath the Rear Section
and insert the Ramp Hooks into the Hook Loops
-
Unfold the short side of the ramp and insert the Ramp Hooks into
the Hook Loops
-
Slide the remaining loading ramp section from beneath the Rear
Section and insert the Ramp Hooks into the Hook Loops
-
Unfold the short side of the ramp and insert the Ramp Hooks into
the Hook Loops
-
Gently step on both sections of the loading ramp to be sure the
Hooks and Loops are fully engaged
7.2 Loading your vehicle
-
Before loading your vehicle, open the Swing Out License Plate
Holder by unscrewing the retaining pin on the top right of the Holder
-
Your license plate will swing open to eliminate clearance issues
Align your vehicle so the vehicle's centerline is near the centerline of
-
your Kendon trailer
-
Gently and slowly ride or push your vehicle onto the trailer
-
Guide the vehicle onto the trailer between the Raised Front Rail on
each side, being careful to avoid contact with it
-
Vehicles with a single front wheel:
o Carefully guide the front wheel into the center and front of
o Advance your vehicle slowly so you do not jump the
o Ensure the front wheel is all the way forward in the Front
-
Vehicles with two front wheels:
o Carefully guide the front wheels to the edge of the Raised
o Advance your vehicle slowly so you do not jump the
o Ensure both front wheels are straight and contacting the
Hold your vehicle in place for tie-down with the vehicle's parking
-
brake, leave it in gear, or place blocks behind the wheels
-
Secure your vehicle to the trailer using the tie-down procedure in
Section 8.0
the Front Triangle
vehicle's front wheel over the Front Triangle
Triangle and straight
Front Rail
vehicle's front wheels over the Raised Front Rail
Raised Front Rail equally
-15-
Advertisement
Table of Contents
