Tie-Down Procedure - Kendon Stand-Up TRIKE/SPYDER/SIDECAR Ride-Up SRL Owner's Manual

-
Replace and secure the loading ramps under the Rear Section of
the trailer as indicated in Section 6.3
-
Close the Swing Out License Plate Holder, secure with retaining pin
7.3 Unloading your vehicle
-
Before unloading your vehicle, open the Swing Out License Plate
Holder by unscrewing the retaining pin on the top right of the Holder
-
Your license plate will swing open to eliminate clearance issues
-
Prepare the loading ramps as indicated in Section 7.1
-
Remove all tie-down straps
-
Carefully and slowly back your vehicle straight backwards off the
trailer
-
Replace and secure the loading ramps under the Rear Section of
the trailer as indicated in Section 6.3
-
Close the Swing Out License Plate Holder, secure with retaining pin

8.0 TIE-DOWN PROCEDURE

KENDON USES A FOUR (4) POINT TIE-DOWN SYSTEM. IT IS NOT
SAFE TO TOW YOUR MOTORCYCLE WITHOUT TYING IT DOWN OR
BY ONLY USING THE FRONT OR REAR TIE-DOWNS. KENDON
RECOMMENDS USING TOP-QUALITY RATCHET-STYLE TIE-
DOWNS TO APPLY ADEQUATE PRESSURE WHEN TYING DOWN.
The following illustrations are suggested tie-down points only. Please
consult your vehicle's owner's manual for proper tie-down locations.
Always use caution when selecting tie-down points on your vehicle; be
sure to consider paint, accessories, interference points, etc. when
choosing tie-down locations. Kendon Industries, LLC is not liable for
damage to your vehicle by tie-downs or other devices used to secure
your vehicle to the trailer.
-16-