Table of Contents
Advertisement
The exhaust gas de-duster (option) is mounted on
the rear of the boiler.
De-ashing, cleaning the heat ex-
4.1
changer and the exhaust blower
Insert the motor with the rod assembly on the side
at the bottom of the boiler (opposite the feed au-
ger).
Insert the rod assembly into the drilled hole (1) on
the opposite side (feed side).
1
Screw the lid tight to the motor and rod assembly
and connect the electric line.
Run the squared shaft end from the de-ashing agi-
tator through the drilled hole in the grate (2) into
the receptacle for the shaped pipe.
Hang into position and screw tight the cover (3).
Mount the exhaust gas blower (4) to the rear of the
boiler.
3
Open the cleaning lid on top of the boiler and insert
the spirals (with the closing plate on the bottom)
into the heat exchanger tubes.
3
2
4
Advertisement
Table of Contents
