RH Baby&child HAND-CARVED ROCOCO LEANER MIRROR Assembly Instructions

PARTS ENCLOSED:
(A) Screws (5)
(B) Plastic anchor (5)
(C) Hangman wall bracket (1)
(D) Bubble Level (1)
(The Screws and Toggle Anchors are meant for drywall only)
TOOLS NEEDED:
Electronic stud finder, #2 "L" Phillips screwdriver,
drill with #2 "L" Phillips bit, pencil
Mirror
Mirror
wall
wall
C.
HAND-CARVED ROCOCO LEANER MIRROR - ASSEMBLY INSTRUCTIONS
A.
B.
Wall Hardware
IMPORTANT SAFETY INSTRUCTIONS:
This hanging system is meant for drywall/stud mounting only. If wall is concrete,
brick or plaster, please consult your local hardware store for assistance. For safety
and ease of mounting, we recommend using two people during installation.
ASSEMBLY & INSTALLATION:
1. Unpack all the parts and plac e them on a protected work surface.
2. Hold mirror at desired location. With a pencil, mark the top outside
arch of the mirror on the wall. These marks will be used to determine
the location of the wall bracket (C).
3. Measure down from the top of the mirror to the top of the mounting hardware.
Mark these measurements on the wall and drill holes into the marks
using the electric drill. Use the bubble level (D) to ensure the placement of the
wall bracket (C) is straight.
4. Insert the wall anchors (B) into the holes. Attach the wall bracket (C)by installing the
screws (A) into the wall anchors with a #2 "L" Phillips screwdriver or drill bit.
5. Mount the Rosette Mirror to the wall by sliding the mirror until the mount bracket
rests on the wall bracket (C).
CARE INSTRUCTIONS:
To clean, wipe gently with a soft, dry cloth.
Avoid the use of harsh chemicals or abrasive cleaners, as they may damage
the mirror's finish.