RH Baby&child REESE UPHOLSTERED BED WITH TRUNDLE Assembly Instructions

REESE UPHOLSTERED BED WITH TRUNDLE - ASSEMBLY INSTRUCTIONS

PARTS INCLUDED

A. HEADBOARD (1)
B. SIDE RAILS (2)
C. FOOTBOARD (1)
D. SLATS (4)
E. PLATFORM PANELS (2)

TOOLS NEEDED

Phillips-head Screwdriver (not included)
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
Bed must be assembled by at least two people.
Please read instructions carefully before assembling bed.
Use the above parts and hardware list to identify each component.
Keep all packing materials until assembly is complete to avoid loss of smaller parts.
1. Stand the Headboard (A) upright and attach Side Rails (B),as shown in Diagram I.
2. Repeat above procedure to attach the Footboard (C).
3. Place the Slats (D) into the cleats on the inside of the Side Rails (B).
Screw the ends of the Slats (D) to the cleats using Screws (1), as shown in Diagram II.
4. Lay the platform panel (E) on top of the Slats (D) and tighten it by using Screws (3), as shown in Diagram III.

CARE INSTRUCTIONS

Spot clean only with a soft, damp cloth.
2
3
Page 1 of 2
Screw (4cm)
1 pc
Allen Key
16 pcs