Maintenance - Dimplex SWM4220 Owner's Manual

Maintenance

• Clean the metal trim using a water-dampened soft, clean cloth. DO NOT use brass
polish or household cleaners as these products will damage the metal trim.
• The motors used on the fan and the flame generator assembly are pre-lubricated
for extended bearing life and require no further lubrication. However, periodic
cleaning/vacuuming of the fan/heater and air intake/output vents is recommended.
The heater should be cleaned and inspected regularly, depending on conditions,
and at least at yearly intervals.
Any electrical repairs of this unit should be carried out by a licensed
WARNING:
electrician in accordance with national and local codes.
Disconnect power by unplugging the power and allowing heater to
WARNING:
cool before attempting any maintenance or cleaning to reduce the risk of fire,
electric shock, or injury.
!
When the heater is not in use, the heater should be stored in a dry
NOTE:
location, away from possible damage. The power cord should be stored properly
to avoid contact with hot or sharp objects.
Remote Control
The battery compartment is located on the back end of the remote control.
1. Press and slide the battery cover open.
2. Insert one 3V (CR2032) battery (included) with the + side up into the battery
compartment.
3. Replace the battery cover.
!
The battery should be removed if the product is to be left unused for a
NOTE:
long time.
Replacing the Remote Control Batteries
• When replacing the battery, replace with new battery of the correct type.
• Non-rechargeable battery is not to be recharged. Exhausted battery is to be
removed from the product and properly disposed of.
18