Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for LMI Technologies Gocator 2075
Summary of Contents for LMI Technologies Gocator 2075
- Page 1 Gocator 2075 Version 3.5.2.123 Revision: A...
- Page 2 LMI Technologies, Inc. Trademarks and Restrictions Gocator™ is a registered trademark of LMI Technologies, Inc. Any other company or product names mentioned herein may be trademarks of their respective owners. Information contained within this manual is subject to change.
-
Page 3: Table Of Contents
Table of Contents Introduction ..........................4 Rut Scanning System Setup ..................... 5 Layout ....................... 5 System Setup ....................5 Software Configuration ..................6 System Operation ........................7 Specifications .......................... 8 Field of View / Measurement Range..............8 Dimensions ....................... 9 Envelope ...................... -
Page 4: Introduction
Introduction 1 Introduction This document provides supplementary information for using Gocator 2075. Reader should refer to Gocator user manual and quick start guide for descriptions and safety precautions of Gocator. Cited sections from the User Manual are shown in italics. -
Page 5: Rut Scanning System Setup
2 Rut Scanning System Setup 2.1 Layout The Gocator 2075 is designed to cover a scan width of up to 4.2m by using 8 sensors mounted in parallel. A Gocator 2075 for rut scanning should typically set the clearance distance (CD) to 800mm and measurement range (MR) to 625mm. -
Page 6: Software Configuration
IP address must be unique. To configure a Gocator 2075 for the first time: 1. Setup the sensor’s IP address. a. Follow the steps in the Running a Standalone Sensor System section. -
Page 7: System Operation
System Operation 3 System Operation The isolated layout should be used. Under this layout, each sensor can be independently controlled by the SDK. The following application notes explain how to operate a multi-sensor system using the SDK. Gocator-2000-2300_Appnote_Multi-Sensor-System_R1.0.zip Explains how to use the SDK to create a multi-sensor system, and multiplex their timing. Gocator-2000-2300_Appnote_Multi-Sensor_Alignment_Calibration_R1.0.zip Explains how to use the SDK to perform alignment calibrate a multi-sensor system. -
Page 8: Specifications
Specifications 4 Specifications 4.1 Field of View / Measurement Range... -
Page 9: Dimensions
4.2 Dimensions... -
Page 10: Envelope
4.3 Envelope...
Need help?
Do you have a question about the Gocator 2075 and is the answer not in the manual?
Questions and answers