Tyre Pressure Monitoring System - Renault Talisman Driver's Handbook Manual

TYRE PRESSURE MONITORING SYSTEM

1
If the vehicle is equipped with the func-
tion, this system monitors the tyre pres-
sure.
Operating principle
Each wheel (except for the emergency
spare wheel) has a sensor in the infla-
tion valve which periodically measures
the tyre pressure.
The system displays the current pres-
sures on the instrument panel 1 and
alerts the driver in the event of insuffi-
cient pressure.
Resetting the standard level
for the tyre pressures
This should be done:
3
2
– when the standard tyre pressure
needs to be changed to adapt to
usage conditions (empty, carrying a
load, motorway driving, etc.);
– after swapping a wheel (however
this practice is not recommended);
– after changing a wheel.
It should always be done after checking
the tyre pressure of all four tyres when
cold.
Tyre pressures must correspond to the
current usage of the vehicle (empty,
carrying a load, motorway driving, etc.).
If the vehicle is equipped with a
navigation system, resetting can
also be done from the multifunction
screen 3. Select the menu "Vehicle",
"Tyre pressure".
(1/3)
Resetting procedure
With the ignition on:
– make short presses on the control 2
to select the tyre pressure display
and, depending on the vehicle, the
"Tyre pressure" function;
– press and hold (around 3 seconds)
the button 2 to launch the reset.
Flashing tyres followed by the mes-
sage "Learning TP initiated" then
"Tyres location in progress" means
that the request to reset the standard
level for the tyre pressures has been
taken into account.
Reset can take several minutes of driv-
ing.
If the resetting is followed by short
trips, the message "Tyres location in
progress" can remain displayed after
successive restarts.
Note: The standard tyre pressure can
not be less than that recommended and
indicated on the door frame.
2.25