Vehicle Connection (Only For Diesel & Gasoline Configuration) - Launch X-431 PRO3S+ User Manual

LAUNCH
B. Battery Clamps Cable: Connect one end of the battery clamps cable to
vehicle's battery, and the other end to the power jack of OBD I adaptor.
4.4.3 Vehicle connection (Only for Diesel & Gasoline Configuration)
The method used to connect the VCI module to a vehicle's DLC depends on the
vehicle's configuration as follows:
A. OBD II Vehicle Connection: Plug one end of the diagnostic cable into the
vehicle's DLC, and the other end into the diagnostic socket of the VCI module,
and then tighten the captive screws.
B. Non-OBD II Vehicle Connection: For vehicles with non-OBD II diagnostic
socket, a non-16pin connector (adaptor cable) is required.
Notes:
a). For commercial vehicles, refer to the above connection method to proceed.
b). For passenger vehicles, replace the "Non-16pin connector" with "OBD I adaptor" +
"non-16pin connector (for passenger vehicles)". Other connections shall also apply.
X-431 PRO3S+ V2.0 User Manual
21