Page 1
GRUNDFOS INSTRUCTIONS AP40-70 Safety instructions and other important information QR99912799 Installation and operating instructions (all available languages) http://net.grundfos.com/qr/i/99912799...
Page 3
AP40-70 English (GB) Safety instructions..........5 Български...
Page 4
Declaration of conformity ........331 AP40-70...
Page 5
Indicates a hazardous situation which, if not avoided, will result in death or serious Product description personal injury. The AP40-70 pumps are a range of Vortex and Single-channel (1-channel) impeller pumps designed WARNING for transferring sewage, effluents, sludge and surface Indicates a hazardous situation which, if water.
~ Hz Insul. class cos ɸ V Δ Made in Germany DK-8850 Bjerringbro,Denmark U.K. importer: o Grundfos Pumps ltd. Grovebury Road, Leighton Buzzard, LU7 4TL Position Description Type designation Maximum head [m] Product number AP70 pump Maximum liquid temperature [°C]...
Code Description Explanation WARNING Crushing hazard Wastewater/ sewage Pump type Death or serious personal injury pump ‐ Make sure the hook is fixed to the Maximum solids size lifting bracket properly. Pump passage 40 = 40 mm ‐ Always lift the pump by its lifting Nominal outlet bracket or by a forklift truck, if the Pump outlet...
Pumps cannot be operated with frequency converter. The pumps must be connected to one of the following: • a control unit with motor-protective circuit breaker, such as Grundfos CU 100 • Grundfos LC 231 or 241 pump controller.
Make sure that all protective circuits. equipment has been connected correctly. Level controllers • Check the oil level. The liquid level can be controlled by the Grundfos LC • Test the insulation resistance. level controllers. Suitable level controllers: CAUTION •...
Page 10
CAUTION CAUTION Biological hazard Hot surface Minor or moderate personal injury Minor or moderate personal injury ‐ ‐ Make sure to seal the pump outlet Do not touch the surface of the pump properly when fitting the outlet pipe, while it is running. otherwise water might spray out.
Page 11
The minimum liquid level is at the top of the pump CAUTION housing. Biological hazard For AP40 and AP50 pumps, Minor or moderate personal injury intermittent (S3) operation between 40°C and 60°C ‐ Flush the pump thoroughly with clean liquid temperature is permitted up to 30%.
3. If connected correctly, the pump jerks damaged when the pump is started. counterclockwise. If the impeller cannot be turned, contact 4. If the direction of rotation is wrong, interchange Grundfos or an authorised service two phases in the power cable. workshop. WARNING Crushing hazard Death or serious personal injury ‐...
Empty the leakage chamber. Not available for all models. For more information, contact When the pump is new or the shaft seal is replaced, Grundfos. check the oil level and water content after one week • Inspect all safety and control devices.
2. Place a 1 litre capacity transparent container Grundfos with details about the pumped liquid. under the oil screw. Otherwise, Grundfos can deny to service the product. 3. Remove the lower oil screw. CAUTION 4. Remove the upper oil screw. Inspect the oil. If the Biological hazard colour is greyish white, the oil may contain water.
Page 15
SIC / SIC Deep groove angular Operating conditions Weights Operating Type (kW) Weight (kg) S1, S3 30% (for AP40 and AP50) mode AP40 (0.7) 0-40 °C. For short periods, a Liquid AP50 (1.0) temperature of up to 60 °C is temperature allowed.
Page 16
The separate collection and recycling of such products will help protect the environment and human health. See also end-of-life information at www.grundfos.com/product-recycling.
BG: Декларация за съответствие на EC/EO We, Grundfos, declare under our sole responsibility Ние, фирма Grundfos, заявяваме с пълна that the products AP40, AP50, AP51, AP60, AP70, отговорност, че продуктите AP40, AP50, AP51, to which the declaration below relates, are in AP60, AP70, за...
Page 18
Standards used: EN 809:1998 + A1:2009 • RoHS Directives (2011/65/EU and 2015/863/EU Standards used: EN IEC 63000:2018 This EC/EU declaration of conformity is only valid when published as part of the Grundfos AP40-70 Safety Instructions (publication number 99926132) document. Bjerringbro, 12th May, 2021...
Page 19
Róbert Kis Technical Product Owner Grundfos Holding A/S Poul Due Jensens Vej 7 8850 Bjerringbro, Denmark Person authorised to compile technical file and empowered to sign the EC/EU declaration of conformity.
Page 20
Declaration of conformity UK declaration of conformity We, Grundfos, declare under our sole responsibility that the products to which the declaration below relates, are in conformity with UK regulations, standards and specifications to which conformity is declared, as listed below:...
Page 21
Argentina China Greece Bombas GRUNDFOS de Argentina S.A. GRUNDFOS Pumps (Shanghai) Co. Ltd. GRUNDFOS Hellas A.E.B.E. Ruta Panamericana km. 37.500industin 10F The Hub, No. 33 Suhong Road 20th km. Athinon-Markopoulou Av. 1619 - Garín Pcia. de B.A. Minhang District P.O. Box 71 Tel.: +54-3327 414 444...
Page 22
Fax: +66-2-725 8998 Fax: + 370 52 395 431 Москва, RU-109544, Russia Turkey Тел. (+7) 495 564-88-00 (495) 737-30-00 Malaysia GRUNDFOS POMPA San. ve Tic. Ltd. Факс (+7) 495 564 8811 GRUNDFOS Pumps Sdn. Bhd. Sti. E-mail grundfos.moscow@grundfos.com 7 Jalan Peguam U1/25 Gebze Organize Sanayi Bölgesi...
Need help?
Do you have a question about the AP40 and is the answer not in the manual?
Questions and answers