Resetting The Ground Fault Interrupt - Graco Therm-O-Flow 200 Instructions-Parts List Manual

Installation
Resetting the Ground Fault
Interrupt
This control panel is equipped with a ground fault inter-
rupt (GFPE) circuit breaker (F
switch is ON, but all lights on the electrical control panel
are off, have a qualified electrician check the ground
fault interrupt.
-
+
PS
123
L
N
F . 4. Reset Ground Fault Interrupt
IG
10
. 4). If the disconnect
IG
1.25 X 3.0 WIRE DUCT
1.25 X 3.0 WIRE DUCT
DC INT
PCB
201 CONN
112
1.25 X 3.0 WIRE DUCT
To reset the ground fault interrupt, have a qualified elec-
trician:
1. Turn OFF the electrical disconnect on the electrical
control panel.
2. Open the electrical control box and locate the
Ground Fault Interrupt switch (GFPE). The ground
fault interrupt will be in a neutral position, between
the ON and OFF positions.
3. Move the GFPE switch to the OFF position, then
move it to the ON position.
4. Close the door and turn ON the disconnect switch.
GND
LUG
GFPE
112
GFPE
TI0565b
311513D