Mode Selection - Dimplex FutuRad FutM2BT Manual

Setting the 'Desired' Room Temperature
The temperature is set using the temperature increase
can be set in the range between 5°C to 30°C. Please note the temperature indicated on the display represents the
desired room temperature. It does not display the current room temperature.
Note - If the temperature set is lower than the room temperature then the product will not emit heat. The temperature
display will be flashing to indicate this. The product is still actively controlling the room temperature and will
automatically turn back on if additional heat is required, i.e. the room temperature lowers or the set temperature is
increased higher than the room temperature.

Mode selection

•
With the appliance activated, press the
•
Select the desired mode using the
•
It will then be necessary to setup the selected mode. Auto mode is an exception as this mode must be pre-set
using the key. See 'Auto Mode Setup'
Note: If an Auto program has not been set, the Auto mode will not be visible/selectable when toggling through the
options.
Manual Mode Setup
•
To select Manual mode navigate to the mode using the
•
Use the or keys to select the desired heat setting (see Heat Selection for details) and confirm the selection
by pressing the
•
The desired room temperature can be adjusted at any point during the Manual mode operation Use the
keys.
Frost Protection (Manual Mode)
Within the manual mode the appliance has a frost protection function. This
setting is useful in areas such as garages to assist in the prevention of frost
damage.
To activate this mode, while in Manual Mode set the temperature to its minimum
setting '5°C', the frost protection symbol (
will cycle ON and OFF to try to maintain a temperature of approximately 5°C
and help protect against frost conditions.
.
It is normal for the 5°C to be flashing when this model is active, it will stop flashing
once heat is required e.g. if the room temperature drops below 5°C.
Note - This appliance cannot guarantee total frost protection, external factors
such as room size, outside temperature, room insulation properties, etc. will
impact on the reliability of this mode.
Auto mode
key.
key.
) will illuminate. When set, the heater
and temperature decrease
Manual mode
Press enter
to confrim selection
and activate mode
key to toggle through the operational modes.
key and confirm selection using the
buttons. The room temperature
Boost mode
Key.
or