Table of Contents
Advertisement
Setting a Heating Schedule,
•
Press the
button. The weekdays numbered 1-7 will be displayed at the top of the screen with the active day
flashing.
•
Use the
or
keys to select the required day and confirm selection using the
the 'On' time for program 1 (block 1) of that day.
•
Use the
,
and
'Setting the Time'.
•
Select the desired heat setting using the
•
Set the desired room temperature to be maintained during the period. Use the
to your desired room temperature and confirm the selection using the
•
Set the program 'Off' hour time using the
•
Set the program 'Off' minute time using the
•
Confirm setting using the
then automatically enter the set up for block 2, 'On'
time.
•
The setup process can be repeated until the full schedule has been set.
Note - It is possible to copy a day schedule and paste it to alternative days. This can simplify the programming process
if the same schedule is required for multiple days, see Copy & Pasting Day Schedules
Programming Considerations & Tips,
•
It is not necessary to set all Program blocks, 1 to 4. The appliance offers the flexibility of up to four blocks per day
but can operate as a single block per day or the schedule that best suits the application.
•
It is not possible set a program to run through mid night. To achieve this operation it is required to setup program
blocks on separate days, for example Day 1 program block must end at or before 23:59 and day 2 program block
can begin at or after 00:00.
•
It is possible to schedule overlapping program blocks, the appliance will automatically give priority to the program
with the highest room temperature setting. Example: if Program 1 is set for 22°C between 13:00-17:00 and Program
2 is set for 25°C between 15:00-22:00. The product will run at 22°C from 13:00 to 15:00, at 15:00 program 2 will
take priority and operate because the set temperature of program 2 is higher
•
It is possible to skip through the program block by pressing the
Program On setup screen.
•
To abort the setup and exit the menu without saving any changes, press and hold the
screen in the programming mode.
•
Similarly to confirm and save any changes from any setup screen press and hold the
•
It is possible to manually change the set room temperature of any auto 'On' program during the program operation
by using the
or
.
buttons to set 'On' time. The hour and minutes must be set, this process is the same as
or
key. The program will
keys. This will have a temporary effect and will not change the program settings.
keys and confirm selection using the
or
and confirm using the
or
and select form the following options.
•
OR
Confirm setting using the
time and return to the day selection screen.
•
Subsequent days can then be programmed, the
copy schedule function can be used or pressing the
key again will save the settings and exit the
program setup.
button only while setting the 'Hour' time on the
key. The screen will then enter
key.
or
keys to increase/decrease
key.
key.
key, this will confirm the
button from any setup
button.
Advertisement
Table of Contents
