Dimplex FutuRad FutM2BT Manual page 10

Boost Mode Setup
•
To select Boost mode, navigate to the mode using the
•
Highlight the desired Boost duration, 30, 60 or 120 minutes, using the
pressing the key.
•
The desired temperature can be adjusted at any point using the
When the boost mode is active, the display will show the boost mode symbol, timer period selected, time remaining
and the desired set temperature.
Time remaining Time remaining
Set temperature
Auto mode Setup
•
To select Auto mode navigate to the mode using the
Note - this mode will only be visible once the time and day has been set and a heating schedule has been
programmed.
Before the Auto mode can be used it is necessary to setup a desired time and temperature schedule. The heating
schedule must be programmed in the following sequence:
1. Select the day to be programmed,
2. Set the desired 'On' (start) time for program block 1,
3. Set the heat mode,
4. Set the desired room temperature,
5. Set the desired 'Off' (end) time for program block 1,
6. Set the remainder of the program blocks and days as required.
Auto Mode Display Screen,
The information displayed on screen will vary depending on the status of the schedule, On or Off.
Auto On, during programmed 'On' block
Display:
Auto mode status: On
Week Day: Wednesday (3)
Time: Next Off time, e.g 18:30
Active Program: Prog 2
Temperature: Controlling at 21
Heat setting: Eco
Boost Icon
key and confirm selection using the
or
or keys.
Time selected
Heat output
key and confirm selection using the
Auto Off, between programmed 'On' blocks
Display:
Auto mode status: Off
Week Day: Wednesday (3)
Time: Next On time, e.g 20:00
Next active Program: Prog 4
Temperature: coming on to control at 25
Heat Setting: coming on in High heat mode
Key.
keys and confirm the selection by
Key.