Nokia IP710 Series Installation Manual page 140

Chapter 8: Troubleshooting
Cause
Solution Verify that you have IP connectivity; ping various hosts on each network.
Cause
Solution Verify that DVMRP is enabled on the interfaces in use.
Cause
Solution Verify that the client is set up for the proper TTL number. Many clients
Problems Interfacing to 1483 Devices (Classical IP)
Cause
Solution Set remote and local devices to the same VC and VP values. Consult your
Cause
Solution Use ipsctl to determine the VC range:
Cause
Solution Set encapsulation to LLC/SNAP. Consult your 1483 device
140
All manuals and user guides at all-guides.com
Under Routing Options in the Routing Configuration section in Voyager,
you can also enable several types of trace options for DVMRP. These
traces are logged into /var/tmp/ipsrd.log.
For information about accessing Voyager and the related reference
materials, see "Using Voyager to Configure the Network Interfaces" on
page 81.
No IP connectivity.
DVMRP is not enabled on the interfaces.
Exceeding TTL on clients.
are set to receive local traffic only one hop away.
Remote and local devices are not configured for the same VC and VP
value.
1483 device documentation.
Remote and local devices are not in the supported VC range of the
network interface card.
ipsctl ifphys:logical interface:max_rxlabel
Encapsulation is not set to LLC/SNAP.
documentation.
IP700 Series Installation Guide