Table of Contents
Advertisement
IP700 Series Installation Guide
All manuals and user guides at all-guides.com
4.
Position the male PMC connectors on the card over the female PMC
connectors on the motherboard.
The two sets of connectors should be aligned with each other. The
four screw holes and four standoffs should also be aligned with one
another.
5.
Push down on the card until it is properly seated on the motherboard.
6.
Place the screws through the standoff holes on the card and into the
standoffs on the motherboard
.
7.
Turn each screw clockwise so that the card is attached to the
standoffs.
Do not tighten completely.
8.
Make sure that all four standoff connections are properly aligned.
9.
To secure the connections, tighten the screws firmly, but do not overly
tighten.
Installing the Encryption Accelerator Card
Screw
Accelerator Card
Standoff Hole
Motherboard Standoff
115
Advertisement
Table of Contents
