Table of Contents
Advertisement
Quick Links
PLOW MOUNT KIT
FOR CF MOTO UFORCE 1000
P/N 34-9020
ASSEMBLY / OWNERS MANUAL
Application
PLOW PUSH FRAME NO. 34-0000 or 34-0070
Before you begin, please read these instructions and check to be sure all parts and tools are ac-
counted for. The following instructions contain details required to install and service the contents of
this kit.
© 2019 Kolpin Outdoors Inc.
REV 00
Advertisement
Table of Contents
Related Manuals for Kolpin Outdoors 34-9020
Summary of Contents for Kolpin Outdoors 34-9020
- Page 1 Before you begin, please read these instructions and check to be sure all parts and tools are ac- counted for. The following instructions contain details required to install and service the contents of this kit. © 2019 Kolpin Outdoors Inc. REV 00...
- Page 2 BEFORE ADJUSTING BLADE: STOP ATV ENGINE; SET AND LOCK BRAKES; RAISE AND LOCK BLADE LOWER BLADE TO DOWN POSITION WHEN BLADE AND ATV ARE NOT IN USE READ BLADE INSTRUCTION SHEETS AND ATV OWNER’S MANUAL © 2019 Kolpin Outdoors Inc. REV 00...
- Page 3 Hex Bolt, Zinc Plated, M8-1.25 x 80mm LG Flat Washer, Zinc Plated, M8 Lock Washer, Zinc Plated, M8 Carriage Bolt, Zinc Plated, M8-1.25 x 25mm LG Flange Locknut, Zinc Plated, M8-1.25 Instruction Guide (not shown) © 2019 Kolpin Outdoors Inc. REV 00...
- Page 4 Spare kits may contain extra hardware that is used for other mount kits. Extra hardware can be discarded. • U-bolts supplied in spare kits may be longer than original and may need to be cut to size. • © 2019 Kolpin Outdoors Inc. REV 00...
- Page 5 Note, a high speed cutting tool (like a Dremel) with a cutting bit will also work. Ill. 1-3 Align sides with angled frame tubes Skid plate nut insert will be near center of square hole © 2019 Kolpin Outdoors Inc. REV 00...
- Page 6 (item #5) will fit thru holes in the plate as shown. Fasten the u-bolts with the M8 locknuts (item #10). (See illustrations 1-4 and 1-5). Note, do not tighten at this step. Ill. 1-4 Ill. 1-5 © 2019 Kolpin Outdoors Inc. REV 00...
- Page 7 M8 locknuts (item #10). Tighten all M8 hardware to specification. (See illustration 1-7). 8MM FASTENER TORQUE: 17 ft. lbs. (23 Nm) Items #9, #10 Universal Mount Plate (not shown) mounting location Ill. 1-7 © 2019 Kolpin Outdoors Inc. REV 00...
- Page 8 Most hardware is general in nature and is easily obtained locally. Be sure to replace with minimum metric class 8.8 specification. Kolpin Outdoors, Inc. Telephone: (763)-478-5800 Toll Free: (877)-956-5746 Fax Number: (800)-245-7569 www.kolpin.com Email: customerservice@kolpin.com © 2019 Kolpin Outdoors Inc. REV 00...
Need help?
Do you have a question about the 34-9020 and is the answer not in the manual?
Questions and answers