Table of Contents
Advertisement
Proper installation: Make sure that your appliance has been
installed correctly and that it has been grounded by a qualified
technician.
To avoid damaging the range, make sure that the connection data
(voltage and frequency) on the data plate correspond to the
building's power supply before connecting the appliance.
When in doubt, consult a qualified electrician.
Installation and maintenance of the gas connection must be
performed by qualified installers, service agencies or gas providers.
During installation, maintenance and repair work, e.g. if the oven
lighting is broken, the range must be completely disconnected from
the power supply (see "Frequently asked questions"). The gas inlet
valve must be closed. It is only completely isolated from the supply
when:
- The circuit breakers have been switched off, or
- the fuses of the electrical installation have been completely
removed, or
- the plug (if present) is removed from the outlet. To do this, pull the
plug not the cord.
- Shut off the gas supply and disconnect the range from the gas
supply. Installation and maintenance of the gas connection must
be performed by qualified installers, service agencies or gas
providers.
Do not use a power strip or extension cord to connect the range
to electricity. These are a fire hazard and do not guarantee the
required level of appliance safety.
For safety reasons, only use the range when it has been fully
installed.
This range must not be installed and operated in non-stationary
installations (e.g., on a ship).
IMPORTANT SAFETY INSTRUCTIONS
9
Advertisement
Table of Contents
