Table of Contents
Advertisement
SET UP DEHUMIDIFIER FOR INSTALLATION
IMPORTANT:
Cut the strap securing the compressor shipping support bracket and remove the strap and shipping bracket .
See Figure 1 .
IMPORTANT:
Remove the ALERT LIGHT and FLOAT Switch cables from around the duct collar .
PACKAGING CONTENT
1. Dehumidifier
2. Inlet/Outlet Collars
3. Literature
a. Installation Instructions
b. Owner's Manual
FIGURE 1 – Remove Shipping Bracket
Remove the wire access cover . Plug the 4-terminal block
connected to the ALERT LIGHT cable into the pins labeled
+ – A B and the remaining 2-terminal block from the cable
into the pins labeled ALERT . See Figure 2 .
4. Parts Bag
a . #8 x 3/8 Screw (1)
b. #10 x 1/2 Screws (9)
c. Wire Nut (2)
d. Bracket for Alert Light (1)
e. Plastic Staples (6)
f. Barbed Fitting & Reducer for Drain Connections
g. Torx Bit
REMOVE SHIPPING BRACKET
CLIP OFF
PLASTIC
STRAP
90-1908
FIGURE 2 – Float Switch and Alert Light Wiring
+ – A B
ALERT
LIGHT
ALERT
90-1948
3
Advertisement
Table of Contents
