8
Chapter
8.1. Camcorder Settings
For camera remote operation, set Camera Control to Enable in the Network Client Mode settings.
"5.4. Network Client Mode Settings"
For details, see
8.2. Camera Remote Test
After checking that Network Client Mode communication is successful, you can check camera remote
operation.
This test is controlled from the CCM UI.
1
Select a camcorder and set the Network Range and the destination receiver (Network RX Station).
2
Issue the Start command for QoS streaming from the CCM.
The camcorder starts streaming.
When streaming is successful, the
appears in the CCM UI preview area.
If you experience any difficulty, see
3
Select the Remote tab on the CCM UI screen.
4
Check that the CCM can control camera zoom, iris, focus, etc.
If you experience any difficulty, see
Setup for "Camera Remote Control"
icon appears on the LCD screen and the streaming picture
"12.3.1. Live Streaming"
"12.3.2. Camera Remote Control"
.
in the Troubleshooting section.
in the Troubleshooting section.
41