Sony PXW-FX9 Setup Manual page 33

5.3.5.1. IP address conflicts
IP address conflicts may occur when using multiple network interfaces simultaneously, depending on the
settings. IP addresses within the same segment may overlap, preventing successful communication.
The following table shows the IP address conflict pattern and the operation that results.
No. IF connection (startup) order
1
1 Modem 1
Modem 2
2 AP mode
3 Modem 1
Modem 2
4 Modem 1
Modem 2
5 ST mode
(Auto/Manual)
6 Modem 1
Modem 2
7 Modem 1
Modem 2
8 AP mode
9 Wired LAN
(Auto/Manual)
10 ST mode
(Auto/Manual)
11 Wired LAN
(Auto/Manual)
2 3
Modem 2 –
Modem 1
Modem 1 Modem 2
Modem 2 Modem 1
AP mode Modem 2
Modem 1
Modem 2 AP mode
Modem 1
Modem 1 Modem 2
Modem 2 Modem 1
ST mode Modem 2
(Auto/Manual)
Modem 1
Modem 2 ST mode
(Auto/Manual)
Modem 1
Wired LAN –
(Auto/Manual)
AP mode –
Wired LAN –
(Auto/Manual)
ST mode –
(Auto/Manual)
Operation
If the segment IP address ranges overlap between
modems, an address conflict error is displayed.
 If the segment IP address ranges overlap between the
AP and the modem, the AP mode address is
automatically changed to another segment and an AP
mode address change message is displayed.
 If the second segment IP address ranges overlap
between the AP and the modem, an address conflict
error is displayed.
 If the segment IP address ranges overlap between
modems, an address conflict error is displayed.
 If the segment IP address ranges overlap between the
AP and the modem, the AP mode address is
automatically changed to another segment and an AP
mode address change message is displayed.
 If the segment IP address ranges overlap between
modems, an address conflict error is displayed.
 If there is an IP conflict between the modem and the ST,
an address conflict error will be displayed and the user
will be prompted to change it.
 If the segment IP address ranges overlap between
modems, an address conflict error is displayed.
 If the IP address of the ST is included in the modem
subnet, an address conflict error is displayed.
If the segment IP address ranges overlap between the AP
and the wired LAN, the AP mode address is automatically
changed to another segment, and an AP mode address
change message is displayed.
If there is an IP conflict between the wired LAN and the ST,
an address conflict error is displayed and the user is
prompted to change it.
33